For transformers with small capacity, 50 Hz power frequency AC can be used, while for transformers with larger capacity, inverter technology has been used to convert 50 Hz power frequency AC into 600 ~ 700 Hz AC, so as to reduce the volume of transformer. After the voltage transformation, it can be directly welded with 600 ~ 700Hz alternating current, or secondary rectification and direct current welding.
The welding parameters are adjusted by timer. The new timer has been computerized. Therefore, the robot control cabinet can directly control the timer without additional interface. The welding tongs of spot welding robot usually use pneumatic welding tongs, and the opening degree between the two electrodes of pneumatic welding tongs is generally only two-stage stroke. Moreover, once the electrode pressure is set, it can not be changed at will.
In recent years, a new kind of electric servo spot welding tongs has appeared. The opening and closing of the welding tongs are driven by servo motor and fed back by code disk. The opening degree of the welding tongs can be selected and preset arbitrarily according to the actual needs. Moreover, the pressing force between electrodes can be adjusted steplessly. Welding robot welding equipment, due to the use of welding tongs, welding transformer installed behind the welding tongs, so the transformer must be as small as possible.
This article comes from the manual welding equipment of water tankhttp://www.cl-onsale.com
Methods to reduce welding deformation and control
I. causes and types of welding deformation causes of welding deformation: welding deformation refers to the deformation of weldments during and after welding. During welding, the molten metal and the base metal near the seam expand and produce plastic deformation. During solidification, the weld and the metal near the seam contract. This is the longitudinal stress and the transverse stress. Make the weld longitudinal and transverse shrinkage, so that the weldment deformation. Because the heat e
Specific differences between grinding machine and polishing machine
Difference: the workpiece processed by grinding machine is rough, and the surface finish of workpiece processed by polishing machine is better, but high finish can be achieved by installing precise grinding wheel on grinding machine. Grinding machine: electric grinder reciprocating electric polishing grinder (also known as file mill). It is widely used in the fine machining and surface polishing of the mold profession. It is a substitute for similar pneumatic products. The main outstanding featu
How to improve the efficiency of straight seam welding machine?
The straight seam welding machine is widely used in ordinary times, and our appeal to the seam welding machine is constantly strengthened. We should know about the operation of the seam welding machine. The straight seam welding machine is not only excellent in spot welding machine, but also excellent in seam welding machine. A good machine must be equipped with a good operator. It is not simple to be a good operator. In addition to the accumulation of time experience, it also needs many tips, s
How to deal with the failure of welding robot?
General welding robot factory has the following shortcomings: a) human shortcomings caused by improper operation, mainly including welding gun damage in welding robot factory, improper loading and unloading of workpieces, and no deformation of positioner follow-up. B) the disadvantages of poor design and manufacture of peripheral equipment mainly include: problems of lifting way switch and cable, quality problems of some components flashed by teaching device. C) improper environmental protection